Edit: Updated the V2 base to make it easier to remove → V2.1

Installation

Attach the base with two screws. Then sling the cables around it and snap the cover in place.

Printing

I added a new version with wider clips that prints without supports.

The base prints on the side. I used PETG for this part

The Cover prints as shown below. I used PLA for this part.

Cable Organizer

Household / Other House Equipment

♥ 4.2k⬇ 5.5k🖨 42 prints

Print profiles

Cover V2.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Cover V1.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Base V2.1.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Base V1.1.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print