This is a remix of @IvoSlanina's great Rope Winder model.

I took some material out of the centre so it prints faster, using 40% less filament. It's still very strong.

I also increased the hole diameters from 4mm to 5.5mm because I couldn't get 550 paracord through the 4mm holes. 

The first image shows 31m/101ft of paracord wrapped around it, the last image is a comparison of hole sizes from the original model and this remix.

I printed this using PLA+ on an MK3S+ using the following settings:

• 0.6mm nozzle
• '0.35 (SPEED)' layer height setting in Prusa slicer
• 2 perimeters
• 15% Grid infill