This tool will help you to quickly tie your fishing line to your hook with a snell knot.

Instructions for using the line tying tool:

1. Insert approximately one foot of fishing line through eye of the hook, and place the hook onto the notch of the tool facing down then hold the back of the line in the thumb grip.
2. Starting toward the tip of the tool, wrap the fishing line around the end 6 to 8 times.
3. Insert the end of the line through the groove of the tool under the loops you’ve just made.
4. Pull the end of the line and tighten the loops onto the hook as you pull the hook off the tool, and trim the excess line below knot.

3D printing specs: 

Printed in PLA in about 30 minutes on my Ender 3 Pro at standard quality, 3 walls, 4 top/bottom layers, 10% lightning fill, tree supports (for the keyring hole). Cura slicer used.

Feel free to Buy Me a Coffee!!

Thanks, and good luck catching the big one!!