Insert 10mm is for an 10mm drill chuck
Insert 13mm for an 13mm drill chuck
I recommend petg because it has very good layer adhesion.
3-4 perimeters should be enough. I took 20% infill and it works well.
V2 now available the only change is a stop now so the insert doesn't fall through.
Now with a Handcrank !
its designed to be a slightly press fit, but if its to lose apply a single drop of adhesive oder scale the knob down to about 98%
Tension Belt/Ratchet Strap Winder (Spanngurt Wickler)
by Verender · original on Printables ↗
Hobby & Makers / Tools
♥ 574⬇ 1.5k🖨 8 prints
Print profiles
Insert 10mm.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Insert 13mm.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Tensioner.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Insert 10mm v2.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Insert 13mm v2.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Hand crank.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print