A String Biplane model with spinning propellor and wheels.
Print the Biplane file at 0.3mm layer height and if using Bambu Studio make sure your wall generator is set to Arachne.
All parts are printed without supports
I found a brim allowed me to print the front file at a faster speed.
To assemble place the 'propellor back' into  the 'engine', push the propellor through and screw in place, then screw the engine and propellor into the front of the Biplane.
String Biplane: No Supports
by 3DPrintBunny · original on Printables ↗
Toys & Games / Vehicles
♥ 434⬇ 2.2k🖨 45 prints
Print profiles
Propellor back.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Front.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Propellor.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Biplane.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print