Summary
A phone holder for the Thrustmaster T300 (RS) wheel. Currently fitting my iPhone 12 very well, but similar phones might also work. Very nice in combination with the Simhub Dash to show some metrics during sim racing.
Printing instructions
- I've printed the mount in Galaxy Black PLA with the following settings:
- Infill: 15%
- Wall loops: 3
- Layer height: 0.20mm
- Make sure to print the clips in PETG, as they need to be a little flexible.
Installation
- Remove the top plate with a small screwdriver, just be carefull not to break it;
2. Install the clips inside the holes, by bending them slightly till they “click” in;
3. Slide the left side of the top mount on the left side of the clips. Then bend the right clips a bit to the right so the mount can snap in. It should now be a steady fit without a lot of movement;
Click your phone inside the holder and enjoy! ;)
Thrustmaster T300 (RS) Phone Holder Mount
by reddalk · original on Printables ↗
Gadgets / Video Games
♥ 118⬇ 1.2k🖨 10 prints
Print profiles
Mount.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Clip.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Mount+15mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print