The helixer!
Its a refillable personal air filter. You will need a bag of activated carbon from your favorite online retailer or an aquarium shop. Does not require supports while printing.
To fill/Refill:
Screw on the outlet screen and pour in some carbon via the other end. tap and shake to get the carbon down to the bottom. repeat this process until full. place the inlet screen on top pointy side out, then screw on the mouthpiece.
Exhale through it to use.
The Helixer! Personal air filter (Smoke buddy, Sploof)
by Comrade_Zach · original on Printables ↗
Gadgets / Other Gadgets
♥ 90⬇ 759🖨 2 prints
Print profiles
Inlet Screen.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Main Body.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Mouth Piece.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Outlet Screen.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print