The 10mm diameter, 3mm height magnets to hold the two halves of the UFO together are optional, as a display piece gravity alone should be sufficient.
Use a piece of wire to hold the UFO over the base at a height and an angle you like.
Blender file included.
UFO_top.stl and UFO_bottom.stl will need supports for the cavity holding the tea light.
Tea Light size: 38mm diameter, 20mm height (not counting the flame)
The Tealight Series:
INVASION! The electric tea light UFO
by DrKronos · original on Printables ↗
Household / Home Decor
♥ 1.4k⬇ 2.5k🖨 54 prints
Print profiles
UFO_peg.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
UFO_bottom.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
UFO_top.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Base.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print