Two models of a traffic cone. I first made the 100 mm one, but later wanted a smaller one. Scaling in the slicer made the wall thickness too small so I redesigned it so the wall thickness stays about 1.5 mm.
Printable without supports.
Traffic Cone
by Erikjuh · original on Printables ↗
Hobby & Makers / Automotive
♥ 303⬇ 3.2k🖨 55 prints
License: Creative Commons — Attribution — Share Alike ↗rcsafetyconetrafficconepylontraffichighwayhighwayman
Print profiles
traffic_cone_100mm.STLDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
traffic_cone_50mm.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print