It’s nice and sturdy, and you can move it around without worrying about it falling forward. This is only a problem for me because I've been playing with them a lot recently and swap decks normally. I also added a copy without the Tech Deck Sign in case you don't want the sign there.

it fits a total of 6 completes. It fits all size Tech Decks including the older smaller decks(girl deck in pic is this size), and the newer decks that are a little larger(the other 5), as well as the Pro Series Tech Decks, and of course professional fingerboards. 

I printed at .2 Layer Height, 15% infill, PLA, on a steel PEI sheet. I had to print it pretty slowly to prevent curling, so I would recommend going much slower than usual if you're using an older printer. Also, I found that the overhang can be tricky if you're using a Bambu printer, so while it can certainly print fine without supports, you can opt to use them if you want to. 

(I didn't enable Z hop, but I might recommend doing so because the nozzle would hit the model and it would kind of wobble mid print, so it might be a good idea but may increase stringing. Mine came out fine but I was a nervous wreck mid print because I was afraid it might fail from getting hit by the nozzle lol)

If you print one post a make, I would love to see it!

-Darth Tommy