This unique Print-in-Place keychain can hold your phone upright or sideways so you can watch videos on the go. Prints in under 40 minutes with no supports and is ready to use straight off the printer. The snap in design is satisfying and functional. The tolerances are 0.3 mm (Added 0.4 and 0.5 mm tol) however, if your printer cannot print that tight you can just scale the model up until it can. I personally use this daily so I thought I would share it with you all :) (took me days to perfect). If you want to sell these, you can use the link below.
Commercial Use: https://cults3d.com/:1242543
No Printer? No Problem, you can order a 3-pack or a 6-pack of these with this link below!
Vulkaza Link: https://vulkaza.com/products/6-pack-foldable-phone-stand-keychain-adjustable
Want to support me?
$1 Donation: https://cults3d.com/:1242536
Foldable Phone Stand Keychain
by BP3D · original on Printables ↗
Gadgets / Portable Devices
♥ 276⬇ 1.7k🖨 26 prints
Print profiles
PIP_Phone_stand_Final.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
PIP_Phonestand_0.5tol.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
PIP_Phonestand_0.4tol.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print