Protective case designed specifically for the TP4056 charging circuit. Featuring a entry point for USB cable, a dedicated exit for power cables, and a secure pressure fit design.
With this circuit things can get quite hot so i designed it to have a air barrier so its not directly touching the plastic.Â
I would recommend printing with some heat resistant plastic and avoid PLA for this one.
Its designed for usb-c but usb micro should fit as well.
Print settings:
Layer height: 0.16mm
Infill: 15%
No supports needed.
Protective Case for TP4056
by ysengard · original on Printables ↗
Hobby & Makers / Electronics
♥ 119⬇ 1.3k🖨 12 prints
Print profiles
tp4056-case-base-v2.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
tp4056-case-top-v2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
tp4056-case-base-large-exit.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
tp4056-case-top-large-exit.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print