Any feedback would be greatly appreciated.
Could be use as a planter, pen holder, etc
Nozzle:
0.4-0.8mm
Layer:
0.24-0.4 (Recommended)
No Supports needed
(Print the pipe upside down)
Scale it as you like :)
Super Mario Bros Pot Plants - Pipe, Brick Block & Question Block
by CalebTimoteo · original on Printables ↗
Household / Outdoor & Garden
♥ 3.2k⬇ 7.8k🖨 55 prints
Print profiles
brick.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
pipe.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
question.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print