This is a very forgiving model. You want a solid black and a good bright white for the bottom and top layers respectively, but in between, any two shades of the same color will work well. Here I use two grays, (JAYO Gray PETG and GEETECH Gray PETG) but Navy Blue and Light Blue or Dark Green and Green etc should all work. Purple and Pink. Red and Yellow and Green and Yellow also work.

Print at 0.08mm layers with 0.16mm as the first layer. 100% infill (NOT tons of perimeters)
The sliders on the bottom of the image indicate the layer number and millimeter value to swap at (it is the same for all models).

First swap at layer 8, 0.72mm (Black → Darker Color)

Second swap at layer 13, 1.12mm (Darker Color → Lighter Color)

Third Swap at layer 17, 1.44mm (Lighter Color → White)

The let the white print until done.

Enjoy and show me your variations!

Man in a Spacesuit Graphic Art

by Steve from HueForge · original on Printables ↗

Art & Design / 2D Plates & Logos

♥ 815⬇ 7.3k🖨 142 prints

License: Creative Commons — Attribution — Noncommercial ↗multicolorfilamentswaphueforgeswapatlayerfilamentpainting

Print profiles

Smoother_Spacema_Front_160x200.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Smoother_Spacema_Front_120x150.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Smoother_Spacema_Front_200x250.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print