None of this would have been possible without the amazing work done by GearHawkStudios

These models let you print and put together a fully functional top shell for a gamecube controller. For the build you will need 6x 8mm m2 bolts, 6x m2 nuts, 4x m3 nuts, and 4x 12mm m3 bolts (You only need m3 nuts and bolts for the 4 screw holes closest to the cable, not the screw holes in the handles). When putting in the m3 nuts, it can be helpful to use some extra long m3 bolts to tighten them, and then swapping to the correct length.

The fusion file lets you make your own analog gate, and is fully parametric.

I have had very good experiences with petg, but should be fine with just about any material.

FDM Gamecube controller top shell

by Bibben · original on Printables ↗

Gadgets / Video Games

♥ 118⬇ 862🖨 10 prints

License: GNU General Public License v3.0 ↗controllergamecubewiismashoemsmashbrosmeleephob

Print profiles

center piece.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
12,5 degrees rounded.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
main body with supports.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
main body.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Standard analog gate.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
buttons and c-stick.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print