Compatibility:

• GalaxyWatch_2-3-4_CatStand_V1 (33.66mm charger puck):
  • Galaxy Watch 2 (not tested)
  • Galaxy Watch 3 (not tested)
  • Galaxy Watch 4
• GalaxyWatch_5-6-7-8_CatStand_V1 (29.33mm charger puck):
  • Galaxy Watch 5
  • Galaxy Watch 5 Pro
  • Galaxy Watch 6 (not tested)
  • Galaxy Watch 7
  • Galaxy Watch Ultra (not tested)
  • Galaxy Watch 8

Before printing I suggest you to measure the diameter of your charging puck.

Designed based on the high poly version created by billyd, so it should be more detailed than the apple watch version.

Designed for the 46mm Galaxy Watch 4 Classic, but it should work for all Galaxy Watches that use the same charging puck. Keep in mind that the magnet is not strong enough to hold the watch at an angle so the watch has to partly rest on the back of the cat. A version is also available for the watches from GW5 to GW7.

The easiest way to put in the charger is to first put the USB cable through the cat and then push the disc in. The cable side of the puck should be facing in direction of the cat's face because there is a small cavity to prevent the cable from bending too much.

To release it, you can push the charger out with the back of a teaspoon or chopsticks (my preferred method) between the legs.

Support is needed for the belly, chin and tip of the tail, Tree support, touching buildplate is recommended.

Rafts: No

Supports: Yes

Resolution: 0.2

Infill: 10-20%