I've messed around with a new cad/modelling software and just ended up with a pistol somehow…

Hardware needed: A bit of 4mm bungee and maybe some tape for the bungee where it interfaces with the lever to avoid too much flex

Assembly, put the trigger in the receiver, secure it with the triggerpin

then put the grip in place, slide the lever over and secure the three parts with the leverpin

then wrap some bungee through the holes and the acceleration slits and tie a knot in the gap under the muzzle.

Cricket - Low hardware stringer pistol

Sports & Outdoor / Outdoor Sports

♥ 225⬇ 1.1k🖨 20 prints

Print profiles

Leverpin.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Triggerpin.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Lever.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Trigger.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Receiver.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Grip.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print