Picatinny Rail Risers in 13mm, 19mm, and 25mm.

prints in orientation as provided without supports (standing on end)

bolt hole is covered by a thin membrane to improve print quality, must be drilled out post-process

PETG recommended as these are intended to flex/pinch when bolted to clamp down.

Hardware needed:

5mm nut with 8mm wrench flats

5mm x 30mm bolt with a head no wider than 9mm

Picatinny Rail Riser

Toys & Games / Other Toys & Games

♥ 184⬇ 1.4k🖨 15 prints

Print profiles

picRiser13.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
picRiser19.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
picRiser25.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print