This system can be stacked infinitely tall. Let's say that you want your system to be 3 layers tall. Then you will need 1 Holder, 3 Sections, 3 Tubes, and 18 Planters. To assemble, just insert the each tube into the hole in the bottom of each section, with the longer side sticking from the bottom of the section. Glue it so that it is watertight. Then, twist the Holder onto a Section, and twist the other sections on top. To water, you can just pour a much water as you want in the top section, and the tubes will just guide the water down into the next section when the water in the top section reaches a certain amount (the water overflows into the tube).
Hydroponic
by Bryant Yu · original on Printables ↗
Household / Outdoor & Garden
♥ 683⬇ 2.1k🖨 1 prints
Print profiles
Planter.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Section.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Holder.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Body25.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print