I made this support inspired by the design of ps5, for the fitting I took the exact measurements of the control and tested it.
In the last photo you can see the recommended slice position.
I recommend using 0.2 layer height or lower
PS5 Wall Stand Dualsense
by Tower 3D · original on Printables ↗
Gadgets / Video Games
♥ 138⬇ 618🖨 4 prints
Print profiles
Right Panel.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Left Panel.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Holow Midle Body.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print