A simple fully printable thumb piano (Kalimba ?) in 3 parts. I set 3 perimeters and:
1) PLA+ with 100% infill for the pads.
2) PLA with 100% infill for the shell.
3) PLA with 10% infill for the intermediate part.
Just glue the parts together with cyano.
I am more or less satisfied of the obtained sound (after some iterations), however is far from the sound from ones in wood and with metal pads, do not forget that it is plastic.
Thumb Piano
by Alpes86 · original on Printables ↗
Hobby & Makers / Music
♥ 466⬇ 990🖨 7 prints
Print profiles
intermediate_part_v2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
pads_v2.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
shell.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print