Print in place. No supports required. I recommend PLA and 0.2 layer height.

Use 5x1mm magnets for the thin cover, 6x3mm for the thick Cover. Need another magnet size? Leave a comment.

Update: There is a latch version now. If it doesn't open, press a little bit against the spine.

The thick cover's spine sticks out a bit but I haven't found a better solution without giving up supportless angles, and stability.

Variation of my other dice book: [Print in Place] Dice Book

Mini Dice Book

Tabletop Miniatures / Miniature Gaming Accessories

♥ 796⬇ 1.9k🖨 34 prints

Print profiles

Mini_Dice_Box_5x1mm.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Mini_Dice_Box_6x3mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Mini_Dice_Box_Latch.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Mini_Dice_Box_10x3mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print