I remixed the design so a 150 cm (60 inches) could fit in, which was not the case with other versions. I also added a little handle to rewind it faster.
Since I printed a couple of those (as gift), the ones that I put a tiny bit of grease works a lot better. If you do so, do it the first time you assemble it, cause, generally when you take it apart, the ears tends to break !
Update (29th november 24); added a 4mm wider one if your tape is wider than 12.5 mm.
Sewing measuring tape winder (remix)
by Gounn · original on Printables ↗
Fashion / Other Fashion Accessories
♥ 205⬇ 950🖨 19 prints
Print profiles
Holder_big.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Center.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Holder + 4mm (wider).3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Center + 4mm (wider).3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print