Yet another phone stand. There is nothing special about this phone stand, made it because I wanted to experiment a little more with creating models in blender.
Perhaps you find it useful, perhaps not. Either way, it's here.
Printed this with PLA Prusa Galaxy Black ( i can't get enough of this!)
Printed the model on it's side with paint on supports for the part of the stand that sticks out. Perhaps there is a more efficient way of doing it. If so, I will be happy to hear from you.
v2 is with a slightly hex different pattern (phone should be less than 9mm thick)
v2_12mm has a wider gap for holding thicker phones (e.g. if your phone has a cover)
Phone Stand
by layerCraft · original on Printables ↗
Gadgets / Other Gadgets
♥ 104⬇ 1.6k🖨 6 prints
Print profiles
phone_stand.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
phone_stand_v2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
phone_stand_v2_12mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print