Nothing super fancy here, just a few pieces.

The bottom/base, the red “wire” part, the tape rolls and strip piece, the reels, and of course the top piece.

You'll need 4 M3 x 12mm screws and 4 nuts.
The red “wire” piece and the strip of tape just need a touch of glue.

Notes of caution/advice:
- You will most likely need to widen the center holes on the tape rolls. I just took a tiny strip of sandpaper (400grit), rolled it up, and ran it through the holes for like 30 seconds each.
- The cutouts for the M3 nuts on the base have super tight tolerances. I balance a nut on top of each hole and use a pair of vice grips (the locking pliers) to gently press the hardware in.

Fallout Holotape Replica

by andotis0105 · original on Printables ↗

Costumes & Accessories / Props

♥ 239⬇ 539🖨 9 prints

License: Creative Commons — Attribution ↗gamingfalloutfallout3falloutnewvegaspipboyholotapevaultec

Print profiles

Wire.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Reels.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Top.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Base.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Tape.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print