This is a Wet Pallet designed for miniature painting. I wanted something cheap and easily accessible, so this is designed to work with generic cellulose sponges and parchment paper. I found mine at Target, but they are also available on Amazon. https://a.co/d/c1G1fps
There is a printable gasket (TPU) to keep the paint fresh overnight and it has a guide on the top piece for cutting perfectly sized sheets of parchment paper using a hobby knife.
(Please note that this is not water tight when clipped, the gasket is meant for moisture retention while still being flat on a table. If you would like to transport it, dump what water is in the pallet before packing away, water retained in sponge should be fine.)
This is sized to be printable on an Ender 3 size build plate (or equivalent).
Print Settings
Printer Brand:
Lotmaxx
Printer:
Lotmaxx Shark
Rafts:
No
Supports:
Yes
Resolution:
.28
Infill:
15
Category: 3D Printing
Wet Pallet for Miniature Painting
by Michael Ramos · original on Printables ↗
Tabletop Miniatures / Miniature Gaming Accessories
♥ 109⬇ 648🖨 5 prints
Print profiles
Wet_Pallet_Bottom.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Gasket.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Wet_Pallet_Top.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Clips.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print