Print in spiral vase mode or normal with 0 top layers, 3 bottom layers, 1 wall. In normal mode you can use infill and print the eggs solid if you want. I printed in vase mode. Each egg file is solid and approximately 55mm wide and 70mm tall. Â The use of a brim or raft will be helpful to get the egg to stick to the bed. Â I also used support at 60 degrees to get the egg to stick to the bed. Â The eggs have a horizontal top end to the print, print slowly. Â
Print instructions
Nozzle size: 0.4 mmÂ
Layer height: Â 0.2mmÂ
Wall line width:  0.8mm  recommended
Print speed:  25mm/sec recommended
Vase Mode enabled (spiralize outer contours in Cura)
Enjoy!
Easter Egg
by xSteve · original on Printables ↗
Seasonal designs / Spring & Easter
♥ 1.2k⬇ 7.8k🖨 126 prints
Print profiles
Egg3.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Egg6.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Egg8.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Egg10.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Egg11.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print