Remix of AAME's great Magnetic Tulip. The model is bigger than the original to look a little better and easier to print. I removed the hole at the bottom of the stem and the tip of the stem. This is meant to be printed in PLA/PETG and does fit together. 

A brim is necessary for the tulip head. 

For both models, I recommend the following expert settings in Prusaslicer. In Filament → Cooling → Cooling Thresholds: set “Slow down if layer print time is below:” to 15 seconds and “Min print speed:” to 5mm/s. There are some very small layers in both models and these settings will allow you to get good print quality while not sacrificing too much speed. 

If the model looks bad, you need to print slower.