This was a well designed model but I didn't like that it was too tall to use with the stock cover. While I was shortening it I saw room for some improvements so I made the following changes:
- Reduced overall height just enough to fit the stock cover
- Added nubs to retain the desiccant tray cover in the tray
- Split the cover in half so you can leave the bottom cover in place and load even more desiccant
I super glued the bottom covers to the tray in my setup but it's not necessary.
Get your Prusameters… Post your Makes!
If you like this project, please don't forget to ❤ Like and ★ Rate!
Printing tips:
- Print everything with the flat side down
- Supports are not needed
- Use a fine layer height and outside/inside wall ordering for best fit and finish
Desiccant Tray for Bambu Lab AMS
by Roland Deschain · original on Printables ↗
3D Printers / Accessories
♥ 1.4k⬇ 18.6k🖨 162 prints
Print profiles
Desiccant Tray.stlIN STOCKDEFAULT
⏱ 22m · 13 g · 127 × 38 × 24 mm · 1 material(s)
Prints on: A1 mini 0.4PLA
Order this print
Desiccant Tray Cover (Top).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Desiccant Tray Cover (Bottom).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Desiccant Tray.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print