This is a 3d printed mold designed based on https://www.printables.com/model/382059-happy-ditto
Ditto should be very soft, so I made a 3d printed mold for Ditto and poured silicone into it.
I added a little bit of red coloring(for silicone use) to make it appear pink.
The mold needs nearly 200g of silicone to make a full-sized Ditto. I only poured around 160g, so there are still some space between the silicone and the mold.
Mold_a and mold_b mates precisely with three round pins and dimples designed into the mold. V-shaped edges between mold_a and mold_b is for filling clay to seal the gaps and also for demolding using wedge-shaped tool.
Some tips:
- Funnel for pouring silicone is recommended.
- Silicone release coating on inner surface of mold is recommended.
- Seal the gap between two molds and between funnel with clay.
- Degas your silicone before pouring!
- Be patient when pouring
- Always check leakage between each 3d printed parts during pouring.
Silicone Ditto(Pokemon) Mold
by Yoshimi Koyama · original on Printables ↗
Tabletop Miniatures / Characters & Monsters
♥ 302⬇ 789🖨 1 prints
Print profiles
funnel.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Ditto mold v5_Ditto mold v5_mold_a.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Ditto mold v5_Ditto mold v5_mold_b.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print