Hardware:
- 4x M3x8mm either sockethead or countersunk screw work.
- 2x Red spade connectors
- small length of wire or cable
- 2part epoxy or other glue
- XT-60 Connector (the one I used: https://www.christians-shop.de/XT60-Connector-Bullet-Hochstromstecker-Set-fuer-RC-LiPo-Akku)
Top: 0.2mm with varible layerheight
Bottom: 0.2mm layerheight
I printed them in PETG but I see no problem in printing them in PLA.
I hope the pictures are explanation enough if not I'm happy to answer questions just leave a comment.
Happy printing :)
Lidl Parkside Battery 20V XT60 Adapter
by Teddyminator · original on Printables ↗
Hobby & Makers / Tools
♥ 421⬇ 2.4k🖨 28 prints
Print profiles
Parkside Battery Connector XT60 Top.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Parkside Battery Connector XT60 Bottom.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print