I loved the concept behind Luke's 3D's original model but it didn't fit my daughter's toothpaste. I also found the model quite hard to assemble as the tolerances were tight and there was little to no horizontal expansion (elephant's foot) compensation built in.

So while I was lengthening the model I decided to make the following improvements:

• Increased shaft and body length by 10mm
• Increased tube slot width on the shaft and body slightly
• Added chamfer to all surfaces that touch the build plate to compensate for horizontal expansion
• Added a bump on the shaft to prevent the tip from coming out while removing the tube
• Stiffened up the ratchet arms
• Improved aesthetics (subjective :))
• Less post processing is required for assembly

Get your Prusameters… Post your Makes!

If you like this project, please don't forget to  ❤ Like  and  ★ Rate! 
 

Printing tips

I've been printing the bodies in PLA and the handle, ratchet, and shaft in PETG.

• 0.4mm nozzle
• 0.2mm layer height
• Support is not required
• Print as shown in the attached screenshot (widest flat faces touching build plate)