nothing too much to say. the fan is disconnected but the tolerances are tight so it might not be able to spin for you. could be a cool challenge for your printer?

you definitely need a resin printer for this, and even still the “fins” around the fan might be too small. if its a problem for everyone i might change it.

i would recommended watching this video: 

to figure out the orientation for the print but tother then that, nothing special.

set the license so you can sell prints of this, feel free to do so since i'm too lazy to do it. just make sure to credit me. ill be grateful if you also like, download and post makes of this. 

 in case its copyrighted, this is actually a fancy looking brick and I've never heard the words graphics card.