Here is an E-stop key cap

I printed mine out of PETG though PLA is probably okay.

No Supports for any of the components needed

I printed my parts at 0.2 layers with a 0.4 nozzle. If you want finer detail you can try a smaller nozzle diameter.

You will probably need to glue the mushroom part of the button onto the base.

I have provided two base models, one with a small amount of support that would need to be cut off after its printed and the other without support. I printed the no support version without issue but if you have issues with the middle piece detaching from the build plate I would try the base with support.

Happy printing and thank you for the support!

E-Stop Key Cap

by Adam Cook · original on Printables ↗

Gadgets / Computers

♥ 1.5k⬇ 2.4k🖨 50 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗capkeyestop

Print profiles

Keycap Mushroom Arrow.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Keycap Mushroom.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Keycap Base No Support.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Keycap Base with Support.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print