Comprised of 37 interlocking pieces, this is a long narrow articulated snake model designed to resemble the Ring-necked snake in family Colubridae, shown in the final images. 

The joints between body links have a range of motion of approximately 45 degrees, and each body link has length, height, and width of approximately 6mm. The total length is 24cm.

It is very difficult to print, as even with good bed adhesion there are still many potential points of failure. It should be printed at no more than 0.24mm layer height, I recommend 0.16mm. Printing with a raft is the best method to prevent a loss of adhesion.