The original model was good looking and very sturdy.
The only problem was that when printing on its side a part of the “upper” edge of the charger cutout would be printed into thin air. To be able to print it without supports or without sagging layers I made this slight variation which has a 45 degree slope on both edges of the charger cutout.
After receiving some feedback I added a variant which has the bottom rear corners strengthened so it doesn't flex that much. You might want to check it out.
Happy printing!
Phone Stand (Improved Charger Cutout)
by janosrusiczki · original on Printables ↗
Gadgets / Other Gadgets
♥ 169⬇ 1.9k🖨 31 prints
Print profiles
Phone Stand Improved Charger Cutout.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Phone Stand Improved Charger Cutout.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Phone Stand Improved Charger Cutout & Strengthened.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print