This is a three part sanding block, made to be very easy to put together.
Scale as you like, but be wary when scaling down, the bolt may need more clearance.
At 100% scale needs about 19cm of sandpaper.
Recommended settings (best to use PLA+ or PETG)
Main block: 20% infill or more, 0.2mm layer, no supports needed
Bolt: use 40% infill, ideally PETG, 4 wall lines, 0.1mm layer.
Wedge: Use whatever settings
None of the parts require supports.
The clearance test is used to figure out if there's enough clearance without wasting material.
Simple Sanding Block / Sanding Tool
by PrismaPrints · original on Printables ↗
Hobby & Makers / Tools
♥ 2.0k⬇ 9.3k🖨 145 prints
Print profiles
Wedge.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Clearance test.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Bolt.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Sanding Block Main.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print