U will need:
- Case - M2.5x10 self tapping screws X7
- Pi - M2.5x6-8 self tapping screws X4
- Mounting to 3060 extrusion (30mm spacing) - M5x10 BHCS or SHCS X2
No supports are needed for this design.
Red faces can be removed for wire/ribbon access (see 3MF)
As with all my designs, I'm open to suggestions..
Raspberry Pi Zero 2 W Case
by Squirrelbrain · original on Printables ↗
Hobby & Makers / Electronics
♥ 676⬇ 2.9k🖨 52 prints
License: Creative Commons — Attribution — Noncommercial — Share Alike ↗casemodularenclosurepiraspberrypiraspberrypicaseraspberrypizero
Print profiles
PI_ZERO_2W_CASE_1.0.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print