Print-in-Place 1.75mm Filament Splicer Guide - no respoling required!
Filament Prusament ASA with 0.2mm layer with variable layer (smallest possible layer) for the filament guiding features hinges and latch.
Proof of concept - Not yet tested.
Use with a soldering gun, slide in the left/right side after connection is made and allow filament to cool.
May need weld bur removal with a knife or sandpaper.
1.75mm Filament-Splicer-Guide Print-in-Place
by akamaka · original on Printables ↗
3D Printers / Accessories
♥ 217⬇ 2.1k🖨 18 prints
Print profiles
Filament-Splicer-Guide.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Filament-Splicer-Guide.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Filament-Splicer-Guide_R1.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Filament-Splicer-Guide_R1.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print