This was an unintentional remix. I actually started a design for a pill container on my own, and then found this one, which was very similar! I reverse engineered their lid design, as my first one was trash, and then I improved upon it as best I could
It is a bit bigger than the original, but I did that on purpose. The original could hold 2 of my medium sleeping pills, while this one can hold 13. The original held 1 of my huge headache pills, while this one holds 8.
I also ran into an issue with the original where upon first use, the threads sheared off instantly, and my pills were stuck inside. I made sure to make the threads much stronger on this model
Overall, I did not INTEND to remix this, but it was so similar in the end, and I referenced it enough, that I felt it was fair to label it a remix
Mini Hanging Storage Container
by Sytan · original on Printables ↗
Hobby & Makers / Organizers
♥ 5.0k⬇ 22.5k🖨 451 prints
Print profiles
Body (High Tolerance).objIN STOCKDEFAULT
⏱ 32m · 9 g · 26 × 26 × 40 mm · 1 material(s)
Prints on: A1 mini 0.4PLA
Order this print
Lid (High Tolerance).obj
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Body (Low Tolerance).obj
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Lid (Low Tolerance).obj
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Flat Lid (Low Tolerance).obj
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Flat Lid (High Tolerance).obj
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print