Yet another soap dish. Features an inclined bottom to make any excess water flow out.
Printing
Material: Doesn't really matter. Go with what you like.
Support: None. The updated shell does not require any support. The original shell (not recommended anymore) does need some support for the lower parts of the fillet.
Infill: No special requirements. Use the minimum amount that is needed to support the top layers.
Perimeters: That's up to your preferences. I personally recommend 3 perimeters to get some durability.
Orientation: I strongly recommend to print the tray upside down. This will give you a much nicer visible surface finish. The shell must be printed bottom down, as it is, obviously.
Changelog
Update 1
As @Faasteer_549552 pointed out in his remix, the overhangs of the rounded edges of the original design are a pain to print. I've added an updated shell where the overhangs are reduced to a maximum of 45°. In my experience that should always print cleanly without support.
Update 2
The tray snaps now into the shell.
Voronoi Soap Dish
by BitBender · original on Printables ↗
Household / Bathroom
♥ 290⬇ 2.0k🖨 35 prints
Print profiles
Shell.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Tray_loose.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Shell_loose.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Shell_snapping.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Tray_snapping.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print