What I changed:
BASE: Added a hole for a 37mm candle. That should save some filament and allow you to turn on/off the candle without having to take it out of the print. This is a very minor change, so if you are not sure what is your candle size just stick with the original base
PANELS: Double panel thickness from 0.2 to 0.4 mm. Opacity is still great (as you can see in the picture) and it is much easier to print with 0.2 layers instead of the original 0.1 layer. Just slice it and print using your traditional 0.2 profile
Christmas Lantern - easier to print
by Rafa · original on Printables ↗
Art & Design / Other Art & Designs
♥ 168⬇ 1.0k🖨 11 prints
Print profiles
Base.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
1a.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
3.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
1b.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print