This is my take at a wall mounted oculus quest stand. I didn't like all the various models that sat on a desk or shelf, or had fiddly arms to clip the controllers on to. This system mounts via two screw holes (or you can use 3M command strips) and has a hanging bracket for the headset and two circular mounds to hold the controllers in place on top. There is a small cubby underneath the headset mount intended to hold the rubber sweat band that is included with the Oculus Quest 2.

This system should be compatible with the original Oculus Quest, and likely other headsets though I have not tested them. 

Prints well at .2mm layer height with 3 perimeters and 15-20% infill. No supports or brim required. Orient flat on its back with the headset mount facing upwards. 

I also sell and fully printed models for anyone who cannot print themselves on my Etsy store.