https://www.buymeacoffee.com/maxt
----------------------
2mm thick
The best quality is achieved if printed face down
Print: 0.2mm
Nozzle: 0.4mm
Support: Not needed
Brim: Not needed
Infill: Not needed, but I'd suggest going with 100% to ensure sturdiness
A tip: If you want to get this print easily off your heat bed, place the heat bed with the printed model in the freezer for 10 to 30 mins. Take it out, and it should pop off quite easily without any breaks/cracks, as shown on the photo below :)
Christmas Deer and Christmas Trees in a bauble (Christmas tree ornament)
by MaxT · original on Printables ↗
Seasonal designs / Winter & Christmas & New Year's
♥ 360⬇ 2.5k🖨 45 prints
Print profiles
Christmas Deer and Christmas Trees in a bauble (Christmas tree ornament).stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print