When slicing the existing Stud with Logo Remix I found the E had some layer missing, the mesh was not quite right, I started with the “Giant Lego Wreath Stud.step” in the original Wreath and added the Logo from an old project I did with Lego Parts.
I decided I wanted a little more variety so modelled a flower (24866) using the LDraw part for the petals and made the rest to similar scale as the Stud, they are shorter on the Z ratio than originals.
I then also added a “Plant Top” (33183), again using the LDraw source, recreating the stem and shorting the Z to be similar scale to the other parts.
I used the existing parts scale and used 0.15 clearance on all parts (same as the original stud).
Giant Lego Wreath Accesories
by Wob · original on Printables ↗
Art & Design / Wall-mounted
♥ 460⬇ 2.0k🖨 17 prints
Print profiles
Lego Wreath Stud Remix with Logo v2.0.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Plant Top (33183)_Shorter.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Lego 5 Petal Flower (24866).stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print