Berserk: Behelit
- Griffith's Egg of the King.
- From the best-selling manga Berserk, by Kentaro Miura.
- I remixed this model from robopillow on Thingiverse to be easier to 3D print.
- I recreated the top cap piece to be more durable.
Printing:
- All files are oriented in the way they should be printed.
- The cap part is oriented like that so the loop is as strong as possible.
- Printed with 15-20% gyroid infill at a .2mm layer height.
- Supports are only necessary on the cap part.
- Recommend printing with a .15mm layer height.
Assembly:
- After removing any supports, make sure the parts fit together.
- The puck part goes between the top and bottom Behelit parts.
- The cap part might have a tight fit, sanding may be necessary.
- Use superglue to bond the parts in place.
- Superglue may not be needed for the cap if the fit is snug.
Please let me know if anything does not fit properly, or if you have any suggestions.
Berserk: Behelit
by Delphant · original on Printables ↗
Costumes & Accessories / Props
♥ 359⬇ 2.4k🖨 17 prints
Print profiles
Puck.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Behelit Bottom.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Behelit Top.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Cap.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print