I found this horse on myminifactory and tried to print it.

Worked out pretty well.

I did not use infill so i had to fuse some parts afterwards. The top of the back seperated due to shrinking. I heated up the part and gently forced them together. Also the front leg which is of the ground broke from its supports. i had to use my hand 3D printerpen to fuse it.

I used custom supports in Cura an also minimal boomsupport.

https://www.myminifactory.com/object/3d-print-pacing-horse-103084

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3 Pro

Rafts:

No

Supports: 

Yes

Resolution:

0.28

Infill: 

none

Filament: Reprapper PLA White

Notes:

I found this horse on myminifactory and tried to print it.
Worked out pretty well.

I did not use infill so i had to fuse some parts afterwards. The top of the back seperated due to shrinking. I heated up the part and gently forced them together. Also the front leg which is of the ground broke from its supports. i had to use my hand 3D printerpen to fuse it.

I used custom supports in Cura an also minimal boomsupport.

EDIT:

I made a new baseplate and removed the one on the horse. Now its easier to make some custom supports to hold the legs. Also i reduced the number of polygones to make the file a lot smaller but keep the details.

Category: Scans & Replicas