🖨️ Print Shop
Hot wheels Connectors: Single, Dual, Triple, Quad, Six

I wanted a clean looking dual connecter which was hidden once the tracks were connected.

Set of connectors which allow you to connect 1, 2, 3, 4, or 6 tracks in parallel.

Dual connector works great for Hot wheels monster trucks.

Supports are required unless you're printing the single connector.

Print Settings

Rafts:

No

Supports: 

Yes

Resolution:

.2


 

Notes:

Settings shouldn't matter much but thicknesses are optimized for 0.2 layer height. I typically use 3 walls. Infill isn't critical since most of the part will be solid due to wall and top/bottom layer heights.

Category: Playsets

Hot wheels Connectors: Single, Dual, Triple, Quad, Six

by 3TDH · original on Printables ↗

Toys & Games / Other Toys & Games

♥ 411⬇ 2.8k🖨 33 prints

License: Creative Commons — Attribution — Noncommercial ↗quaddualmonsterwheelshottrucktrackconnectorsinglethingiversemonstertrucktriplehotwheelssixdiecasthotwheelstrackmonsterjam

Print profiles

  • hw_connector_single_no_support.stlDEFAULT

    ⏱ time and weight estimated after preparation · 1 material(s)

    Made to order: we prepare this file when you order, which adds a few minutes before printing starts.

    Prints on: A1 mini 0.4PLA

    Order this print

  • hw_connector_single.stl

    ⏱ time and weight estimated after preparation · 1 material(s)

    Made to order: we prepare this file when you order, which adds a few minutes before printing starts.

    Prints on: A1 mini 0.4PLA

    Order this print

  • hw_connector_dual.stl

    ⏱ time and weight estimated after preparation · 1 material(s)

    Made to order: we prepare this file when you order, which adds a few minutes before printing starts.

    Prints on: A1 mini 0.4PLA

    Order this print

  • hw_connector_triple.stl

    ⏱ time and weight estimated after preparation · 1 material(s)

    Made to order: we prepare this file when you order, which adds a few minutes before printing starts.

    Prints on: A1 mini 0.4PLA

    Order this print

  • hw_connector_quad.stl

    ⏱ time and weight estimated after preparation · 1 material(s)

    Made to order: we prepare this file when you order, which adds a few minutes before printing starts.

    Prints on: A1 mini 0.4PLA

    Order this print

  • hw_connector_six.stl

    ⏱ time and weight estimated after preparation · 1 material(s)

    Made to order: we prepare this file when you order, which adds a few minutes before printing starts.

    Prints on: A1 mini 0.4PLA

    Order this print