I used Polycam, Blender, and Fusion 360 to create this low-poly remote holder.

I'm excited to use this workflow to make more things!

Print it with some shiny PLA to get maximum reflections from the faces of this low-poly design.

Print with supports:

Use the 3mf file in Prusaslicer or the gcode for my setup.

Consider scaling up a bit for large remotes.

I also highly recommend that you follow @Misha.in's make of the design:

A great model that enlivened the living room. First, I printed out the attached gcode, but I found a few flaws in it. Mainly it was very light and fragile. Therefore, I doubled the number of perimeters to 4 and poured sand into the model during printing. Now the hand is steady as a rock.

Also, Special thanks to @TritonPrint3D for the photo. Check @TritonPrint3D on YouTube:

Hand Holder

by Paul · original on Printables ↗

Household / Living Room

♥ 1.7k⬇ 5.4k🖨 33 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗holderscandesktoplowpolyplaystationhandknifeholstersunglassesnintendoswitchapplecontrollertvdvdremotecoffeetoolholderandroidcradlehandyspongespatulacaddyremotecontrolnetflixglassesorganizebookendairplayxboxamazonfirespoonrestrokubluraychromecastheldpolycam

Print profiles

Left Hand Holder v3.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Right Hand Holder v3.1.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Hand Holding Remote v3.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print