Remixed a caliper holder by Klave (linked) for the honeycomb storage wall. Hexagon's (connector) faces was offset by -0.15 for snap fit into the blank insert needed for the wall storage. The blank insert can be downloaded at https://www.printables.com/model/152592-honeycomb-storage-wall

Print settings:

Print vertically.

Layer Height : 0.2

Perimeters: 4

Infill: 20%

Update 12/07/2022: Added version that can hold a single CR2032 battery for the calipers.

Install the battery into the holder with the + facing up. There is a circle indicator on the holder

I hope you enjoy printing the design! To help me keep designing and uploading more things, you can tip me via 'Buy Me a Coffee' here: https://www.buymeacoffee.com/Jungl3

HSW Caliper and CR2032 Holder

by Jungl3 · original on Printables ↗

Hobby & Makers / Tools

♥ 896⬇ 5.4k🖨 144 prints

License: Creative Commons — Attribution — Noncommercial ↗caliperholderhoneycombstoragewall

Print profiles

HoneycombCaliperHolder.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Caliper_Battery_Holder.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
cr2032holder.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print